Viking Electronics K-202-DVA Two-input multi-number auto d

Viking ́s K - 202 - DVA is a fully programmable two - input multi - number auto dialer designed for emergency and non - emergency message notification. The K - 202 - DVA has two dry contact inputs each of which can dial up to seven 32 - digit phone numbers and play a message up to 1 minute in length specific to that input.
Messages can be recorded locally or remotely with a total message time for both inputs of two minutes. The K - 202 - DVA has call progress detection capability with normal and fast busy call pickup CPC and ring - no - answer detection.

Programming is easily done with a Touch Tone phone.

Security/burglar/fire alarm notification.

System alarm or equipment malfunction notification.

Environmental warning notification.

Contacting personnel via numeric pagers.

Non - volatile memory (no batteries required).

Stores up to seven 32 - digit phone numbers ( fourteen 32 - digit numbers total ).

2 minutes of record time ( 1 minute per input ).

Programmable message repeat counter.

Programmable lap counter.

Two inputs programmable normally open or normally closed and enabled or disabled.

Programmable ring delay for remote programming and alarm polling.

Programmable qualifier timer for each input ( time for an event to be qualified as an alarm ).

Programmable resume timer for each input ( time following reset for input to become active again ).

Call progress detection.

Programmable ringback limit for call progress.

Remote security and access codes.

Local or remote programming and recording.

Compatible with the RC - 2A and RC - 3 remote DTMF controllers.

Phone numbers may be programmed as pager numbers (no voice message played).

Power: 120V AC/12V DC 500 mA UL listed adapter provided.

Dimensions: 133 mm x 91 mm x 44 mm (5.25" x 3.6" x 1.75").

Environmental: 0°C to 32°C (32°F to 90°F) with 5% to 95% noncondensing humidity.

Talk Battery: 12V DC.

Touch Tone Dialing: 120 ms on/off 50 ms on/off.

CPC Detection Time: 320 ms minimum.

Message Record Time: 2 minutes.

Sampling Rate: 64 K (equivalent).

Input Detection Time: 80 ms with Qualifier Timer set to 0.

Resolution Qualifier Timer: 1 second to 18 hours.

Resolution Resume Timer: 1 second to 18 hours.

Connections: (1) RJ11 jack for telco connection (1) 4 position screw terminal block for inputs.